Hawai'i Volcano Blog

Volcano Watch: Using acoustic signals to identify the start of the 2022 Mauna Loa eruption

Play
Listen to this Article
5 minutes
Loading Audio... Article will play after ad...
Playing in :00
A
A
A

“Volcano Watch” is a weekly article and activity update written by U.S. Geological Survey Hawaiian Volcano Observatory scientists and affiliates.

The lava flow erupting from Mauna Loa and the glow it created in nighttime skies over the island during the 2022 eruption. (File photo by Nathan Christophel/Big Island Now)

The 2022 eruption of Mauna Loa occurred late in the evening of Nov. 27. The eruption was preceded by intense earthquake activity about half an hour prior to glowing lava seen on USGS Hawaiian Volcano Observatory webcams.

How does the observatory narrow down the precise time that the eruption started?

Remote cameras are critical to confirm eruptive activity but, in many cases worldwide, views of the activity can be obscured. Clouds, fog or volcanic gas can block views, or cameras might not cover the eruption site. Hence, the Hawaiian Volcano Observatory and other observatories around the globe establish numerous methods to attempt to identify eruption activity even if the volcano cannot be clearly seen.

One way to monitor volcanoes is by measuring the sounds of an eruption.

These sounds can rapidly travel away from the eruption vent in the same way a rock thrown into calm water can make ripples that move away from the “plop point.”

ARTICLE CONTINUES BELOW AD
ARTICLE CONTINUES BELOW AD

The global volcano monitoring community routinely installs clusters of acoustic sensors called arrays on the flanks of volcanoes that can measure the audible noise (sounds we can hear) and the inaudible noise, which have frequencies that human ears can’t sense (infrasound). Computer processing is then used to look for signals that come from a distinct direction, similar to the way humans train their ears and brains to determine from where sounds come.

The Hawaiian Volcano Observatory monitors our volcanoes using rapidly processed near real-time data from acoustic arrays that measure pressure changes around our most active volcanoes, Kīlauea and Mauna Loa. The grouped sensor arrays are deployed in the field to allow computers to look for correlations in acoustic energy from Hawaiʻi’s likely eruption centers.

The processing compares all waveforms of the array and looks at consistency (called coherency) of the waves under a range of conditions. In the plots, strong waveform coherency are marked by red and orange dots and incoherent waves are marked by light and dark blue.

As an analogy, incoherent sounds are like the sounds you hear in the middle of a forest on a windy day and more coherent sound would be from a car honking on the road.

Panel A is a thermal image showing first observation of strong ‘lava glowing’ at Mauna Loa, time-stamped 11:36 p.m. Nov. 27, 2022. An example waveform from the array of sensors at the ‘Āinapō (AIND) field station is shown in panel B. Coherency plots of wave velocities are shown in panel C and the direction of the computed eruption source compass direction, relative to the ‘Āinapō array, is shown in panel D. The colored dots in panels C and D represent incoherent signals (shown in light and dark blue) and coherent signals (shown in red, orange and yellow). The black vertical line in panels C and D marks the early onset of the eruption at 11:23 p.m. The gray vertical line shows the time when the thermal image in panel A was taken. Both of the vertical lines mark times before changes in the acoustic processing because it takes about 2 minutes for sound to travel from the eruption vent to the ‘Āinapō array. (USGS graphics)

Coherent acoustic signals often have characteristics that allow them to be distinguished by the processing of array data, and two good indicators of coherency come from the wave speed and wave direction across the array.

ARTICLE CONTINUES BELOW AD

For example, near the surface of the Earth sounds usually travel at speeds of about 300 to 400 yards per second. The Hawaiian Volcano Observatory’s ‘Āinapō infrasound array is located in Hawai‘i Volcanoes National Park and has a compass direction of about 300 degrees, pointing back to Mauna Loa summit. Automated detection can use these characteristics (coherency, wave speed and direction) to improve our ability to rapidly understand when an eruption is occurring at the Mauna Loa summit.

Panel D of the figure accompanying this week’s “Volcano Watch” shows that the compass back direction becomes very stable at about 11:25 p.m., which indicates that mild eruptive activity had started. Its timing was probably about 2 minutes earlier, at about 11:23 p.m., given that it takes about 2 minutes for sound to travel from the summit of Mauna Loa to the ‘Āinapō array.

Indeed, panel A of the figure shows that by 11:36 p.m., lava flows being generated by the new eruption were rapidly expanding across Mokuʻāweoweo, the Mauna Loa summit caldera. The progression and expansion of the lava is followed by a strong intensification of that activity around 11:40 p.m.

This shows the value of using multiple lines of information to evaluate eruptive activity.

In addition to acoustic methods, staff at the Hawaiian Volcano Observatory use a full range of monitoring methods including seismic, deformation, gas and webcam imagery. The data collected improve our situational awareness; evaluating the different datasets together can help scientists to understand the volcanic processes happening at any one time.

ARTICLE CONTINUES BELOW AD

This, in turn, helps the observatory keep the public well-informed about our active volcanoes.

Volcano Activity Updates

Kīlauea is not erupting. Its USGS Volcano Alert level is Advisory.

Disbursed seismicity continues below Kīlauea’s summit and along the Koa‘e fault system southwest of the caldera. Average earthquake counts in this region during the past week have remained below 40 detected events per day, well below the amount detected during the January to February intrusion or prior to recent summit eruptions.

Tiltmeters near Sand Hill and Uēkahuna bluff continued to record modest inflationary trends throughout the past week. No unusual activity has been noted along the rift zones.

Mauna Loa is not erupting. Its USGS Volcano Alert Level is at Normal.

Webcams show no signs of activity on Mauna Loa. Summit seismicity has remained at low levels during the past month. Ground deformation indicates continuing slow inflation as magma replenishes the reservoir system following the 2022 eruption. SO2 emission rates are at background levels.

Two earthquakes were reported felt in the Hawaiian Islands during the past week: a magnitude-3.1 quake located 6 miles east-northeast of Pāhala at a depth of 20 miles at 9:06 p.m. March 23 and a magnitude-3.1 earthquake 1 mile south-southwest of Pāhala at a depth of 20 miles at 9:45 p.m. March 22.

The Hawaiian Volcano Observatory continues to closely monitor Kīlauea and Mauna Loa.

Visit the Hawaiian Volcano Observatory website for past “Volcano Watch” articles, Kīlauea and Mauna Loa updates, volcano photos, maps, recent earthquake information and more. Email questions to askHVO@usgs.gov.

Sponsored Content

Subscribe to our Newsletter

Stay in-the-know with daily or weekly
headlines delivered straight to your inbox.
Cancel
×

Comments

This comments section is a public community forum for the purpose of free expression. Although Big Island Now encourages respectful communication only, some content may be considered offensive. Please view at your own discretion. View Comments